113 T 111″ X 63″, 32″ MAX STROKE, 4-POST

*TO USE THE FULL 111” X 63” NOMINAL BED AREA, THE TWO OPTIONAL SWING-IN SAFETIES WOULD HAVE TO BE REMOVED. WITH THE “SWING-INS” INSTALLED THE LEFT TO RIGHT CLEARANCE IS APPROX 86”. THE SLIDE OVERALL IS APPROX 118” X 63”. THE BED OVERALL IS APPROX 131” X 64”. APPROX 69” F TO B BETWEEN THE POSTS. (NOTE: IF A MOLD/TOOL CAN SPAN THE TWO INSETS THEN THE F TO B DIMENSION COULD BE UP TO APPROX 90”. IF A MOLD/TOOL WAS INSTALLED FROM THE LEFT OR RIGHT SIDES IT COULD BE UP TO APPROX 118” X 69”). THERE ARE TWO OPTIONAL PNEUMATIC 43.75” TALL SWING-IN SAFETIES (WHEN USED THEY EFFECT BED CLEARANCE). ONE 8” BORE CYLINDER WITH A 4” DIA ROD AND WITH A PREFILL VALVE AND TWO 4” BORE CYLINDERS WITH 2.5” DIA RODS RATED TO 3,000 PSI WITH APPROX 32” MAX STROKE. MAX DAYLIGHT IS APPROX 48.5”. FULLY GUIDED WITH 36” BUSHINGS ON 6” DIA POSTS. OPERATOR HEIGHT IS APPROX 30”. BED AND SLIDE HAVE EIGHT 0.75” T-SLOTS ON APPROX 12” CENTERS. TWO LEFT TO RIGHT GROOVES IN BED APPROX 2.75” X 1.25” DEEP. 48” LIGHT CURTAINS ON FRONT. SAW-TOOTH RATCHET SAFETY BAR. MESH FENCING AROUND PRESS WITH SOME ELECTRICALLY INTERLOCKED DOORS. FENCING MOUNTS ONTO A 168” X 96” X 1” STEEL PLATE THAT THE PRESS CAN SET ON. SAFETY RAILING ON TOP OF PRESS. TOP-MOUNTED HYDRAULIC SYSTEM: 25 HP MOTOR (230/460V; 1800 RPM). CONTINENTAL PUMP: HPV-29B30-RF-0-1R7-B; RATED TO 3,000 PSI. APPROX 250 GALLON TANK. PREFILL VALVE ON CENTER CYLINDER. APPROX SPEEDS: 270 IPM FAST CLOSE; 5-90 IPM PRESSING; 450 IPM FAST OPEN. (NOTE: WITH HYDRAULIC MODIFICATIONS THE FAST CLOSE COULD BE INCREASED TO 650 IPM). ELECTRICAL CONTROL SYSTEM: ALLEN-BRADLEY MICROLOGIX 1500; AUTOMATION DIRECT HMI; LINEAR TRANSDUCER; E-STOP; START BUTTON; ETC…OVERALL APPROX DIMENSIONS: 156” X 108” X 210” TALL. APPROX 70,000 POUNDS. SOME PRINTS. ITEM #2664C.