350T* 84”X72”, 100″ DAYLIGHT, 60” STROKE, 4-POST

PRESS WAS SET UP WITH AN 84” X 48” X 3” T-SLOTTED PLATED ATTACHED TO THE SLIDE AND A 78” X 40” X 3” T-SLOTTED PLATE ON THE BED WHICH COULD BE MOVED IN AND OUT (WOULD REQUIRE SOME WORK TO MAKE SLIDE-OUT BED FUNCTIONAL). THE OVERALL BED SIZE IS 100” L TO R; THE DISTANCE FRONT TO BACK BETWEEN THE POSTS IS 54”. NOMINAL BED SIZE WITH T-SLOTTED PLATES REMOVED WOULD BE 84” X 72”. MAX DAYLIGHT WITH PLATES REMOVED IS APPROX 100”. MAX STROKE IS APPROX 60”. TOTAL OF THREE CYLINDERS: TWO ARE 14” BORE WITH 7” RODS; APPROX 3” ROD END PORTS AND EQUIPPED WITH OLMSTED PRE-FILL VALVES. THE CENTER CYLINDER WHICH IS USED FOR FAST TRAVERSE IS 7” BORE WITH A 4” DIA ROD AND HAS APPROX 3” PORTS WITH 4-BOLT FLANGES. THERE IS A 6” X 6” SAW-TOOTH SAFETY CATCH WITH HYDRAULIC LOCK. FULLY GUIDED WITH 10” BUSHINGS ON 6” DIAMETER TIE RODS. THERE ARE TWO MANUAL SWING-IN SAFETY STOPS THAT ARE 87” LONG. BED AND SLIDE HAVE SEVERAL THRU-HOLES AND DRILLED AND TAPPED HOLES. LIFT CAPACITY AT 1000 PSI IS APPROX 13 TONS. TOP-MOUNTED HYDRAULIC SYSTEM: 30 HP MOTOR (230/460 VOLTS; 1800 RPM); VICKERS PVB 45A RS F 10 CA11 *(NOTE: THIS PUMP IS LIMITED TO 1000 PSI WHICH WOULD RESULT IN APPROX 175 TONS; THE ADDITION OF ANOTHER MOTOR AND HIGH PRESSURE PUMP IS REQUIRED TO REACH 350 TONS); APPROX 135 GALLON TANK; FILTERS; VALVING; TWO OLMSTED PRE-FILL VALVES (PRT-0406-B28); ETC… APPROX SPEEDS: 250 IPM FAST CLOSE; 1-30 IPM PRESSING; 380 IPM FAST OPEN. SOME RELAY CONTROLS ON PEDESTAL. OVERALL DIMENSIONS APPROX: 110” L TO R X 94” F TO B X 25’ TALL (INCLUDING 9” TALL BASE PLATE). APPROX 85,000 POUNDS. C. ITEM #1941C.